TEAC IDE/HD INFORMATION

MASTER/SLAVE STRAP CONFIGURATION

Models:  S340, 380 & 3105

________________S0 ____S1_____S2_____S3___
Single Drive:   ON     OFF    ON     ON
      Master:   ON     ON     ON     ON
       Slave:   ON     ON     OFF    ON


Models:  SD3210 & 3240

________________SP_____S0_____S1_____S2_____S3___
Single Drive:   ON     Off    Off    OFF    OFF
      Master:   ON     OFF    OFF    OFF    ON
       Slave:   ON     OFF    OFF    ON     ON

Note: Jumpers are located at the rear of the drive to the right of
the data cable connection and are read right to left. S0/SP is 
located at the outer most edge of the case.


CMOS (BIOS) SETUP: CAPACITY = HDS * CYL * SEC* 512 BYTES

_Model_____Type____Heads_____Cyl._____Sec._____W-Pre_____Land-Z__
 SD340      17      5        977       17       300       977
 SD380     U-Def    4        1025      40       300       1025
 SD3105    U-Def    5        1025      40       300       1025
 SD3210    U-Def    10       1025      40       300       1025
 SD3240    U-Def    8        965       62       300       965

The user defined drive type is typically type 47, however check your systems 
BIOS for its User Defined Drive Type. Then enter the above parameters
for the model you have.

The abouve information was obtained directly from TEAC. Thier automated 
FAX on demand is (213) 727-7629.